Artemide inc.250, Karin Lane, Hicksville (NY) 11801T. +1 631 694 9292 | infousa@artemide.net | www.artemide.net

Artemide Ltd.11105, rue Renaude Lapointe, Montréal (QC) H1J 2T4

T. +1 514 323 6537 | infocanada@artemide.net | www.artemide.net1

37 CUBELOW VOLTAGE Assembly instructions

Y503-11528rev 0.1

Attention: Read and understand these instructions before installing fixture. This fixture is intended for installation in accordance with National Electric Code and local regulation: To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. This equipment is guaranteed only when used as indicated in these instructions; therefore they should be kept for future reference. To prevent electrical shock, turn off power supply before carrying out any connection or maintenance operations.

Your box should contain ;complete fixture STEP 1 1. Cut a circular opening in the ceiling

STEP 2 1. Unscrew junction box cover and remove.

STEP 2A For Low-volatage wires :

1. Pass wire through bushing.2. pass inside strain relief and tighten the screws

STEP 3 1. Make appropriate con-nections.

2. Screw junction box cover back.

STEP 2B For BX conduit or Loomex wires :

1. Remove bushing, screws and strain relief bracket2. Install BX conduit or loomex connector (not included).

3.1

D D = 2 1/4’’

5.7 cm

2.1

2B.1

2A.1

2A.2

FIXTUREWIRES

CEILINGWIRES

Black

White White +

Black -

strain relief bracket

2B.2

This luminaire is compatible with 12 Volts AC or DC circuits.

Artemide inc.250, Karin Lane, Hicksville (NY) 11801T. +1 631 694 9292 | infousa@artemide.net | www.artemide.net

Artemide Ltd.11105, rue Renaude Lapointe, Montréal (QC) H1J 2T4

T. +1 514 323 6537 | infocanada@artemide.net | www.artemide.net2

37 CUBELOW VOLTAGE Assembly instructions

Y503-11528rev 0.1

STEP 4 1. Push mounting springs upward.2. Insert the fixture in the ceiling.3. Fixture installed

4.3

4.14.2